User Tools

Site Tools


mechanical_overview

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
mechanical_overview [2020/09/24 11:11]
richard
mechanical_overview [2021/08/16 15:22] (current)
Line 7: Line 7:
   - Aluminum extrusion frame for supporting the microfluidics devices   - Aluminum extrusion frame for supporting the microfluidics devices
   - ATX power supply unit (PSU) normally used with desktop computers   - ATX power supply unit (PSU) normally used with desktop computers
-  - Tubing (1/8 inch and 1/16 inch diameters for connecting the LabAutoBox to robotics for doing 8 channel pipette liquid handling+  - Tubing 1/8 inch and 1/16 inch diameters for connecting the LabAutoBox to robotics for doing 8 channel pipette liquid handling
 <figure> <figure>
 {{:labautobox_mechanical_front_view.png?400 |LabAutoBox front view CAD not showing the tubing}} {{:labautobox_mechanical_front_view.png?400 |LabAutoBox front view CAD not showing the tubing}}
Line 16: Line 16:
 // //
 // //
-// +
-//+
 ===== Electronic box plug reference ===== ===== Electronic box plug reference =====
 +
 <figure> <figure>
 {{: labautobox_mechanical_plugs.png?300|LabAutoBox electrical plug view}} {{: labautobox_mechanical_plugs.png?300|LabAutoBox electrical plug view}}
Line 24: Line 24:
 </figure> </figure>
  
-The electronic box is used for controlling XYZ gantrys (like 3D printers, old laboratory automation systems, labbots). The attached Raspberry Pi runs the LabAutoBox browser based software and on the front of this electronic box are connections for hooking the different devices for doing liquid handling based laboratory automation.  +// 
-  * X - X motor and endstop +// 
 + 
 + 
 +The electronic box is used for controlling XYZ gantrys (like 3D printers, old laboratory automation systems, labbots). The attached Raspberry Pi runs the LabAutoBox browser based software and on the front of this electronic box are connections for hooking the different devices for doing liquid handling based laboratory automation. 
 + 
 +  * X - X motor and endstop
   * Y - Y motor and endstop   * Y - Y motor and endstop
   * Z - Z motor and endstop   * Z - Z motor and endstop
Line 33: Line 38:
   * P - Pressure compensation vessel electrocaloric liquid level sensor   * P - Pressure compensation vessel electrocaloric liquid level sensor
   * L - Liquid pumps (wash, waste and PCV)   * L - Liquid pumps (wash, waste and PCV)
-  * H3 - Heater controller unit 3+  * H3 - Heater controller unit 3 
  
mechanical_overview.1600971076.txt.gz · Last modified: 2021/08/16 15:21 (external edit)